Applying TransfersHow to Apply Waterslide Transfers1. Surface must be clean and free from grease. cellulose or Two Pack finishes should be left for at least one week before applying transfers to allow vapours to escape. DO NOT FLAT […]Read More How To Apply Vinyl Transfers (Dry Method)1. Surface must be clean and free from grease. 2. The graphic is sandwiched between a waxed backing paper and a low tack application tape which is folded around the backing at the ends. […]Read MoreHow to Apply Tank Lines (Wet Method)1. Surface must be clean and free from grease. 2. The vinyl is sandwiched between a waxed backing paper and a low tack application tape. Make sure your surface and transfers are at room temperature. […]Read More How to vinyl wrap a Motorcycle Side PanelStep 1: Surface must be clean and free from grease. Step 2: Roll out your wrapping vinyl with the back side facing up and place your side panel on top of it. Step 3: Now position it so that you have […]Read MoreHow to Apply Tank Lines (Wet Method)1. Surface must be clean and free from grease. 2. The vinyl is sandwiched between a waxed backing paper and a low tack application tape. Make sure your surface and transfers are at room temperature. […]Read More How to apply Pre-Spaced Vinyl Registrations to a Rear Motorcycle Number Plate1. Number Plate surface must be clean and free from grease. 2. The vinyl is sandwiched between a waxed backing paper and a low tack application tape which is folded around the backing at the ends. […]Read More
